|
|
||||
|
|||||
|
|
||||
|
|||||
|
Technical
Quickly Remove Rust with Blue Wonder Gun Cleaner... Apply Blue Wonder Gun Cleaner to rusted areas and work in with 0000 steel wool or a brass brush until the rust is loosened. (This will not harm the bluing!) For heavier rust, work gel in and let sit for 5 -10 minutes. Wipe areas with a clean, dry cloth and apply quality gun oil to prevent further rusting. For bare metal areas where harming the bluing is not a concern, Blue Wonder Gun Cleaner may be applied with more abrasive products such as ScotchBrite abrasive pads, more coarse steel wool, steel brushes, etc. (Use caution as these type abrasive materials will affect the surface finish of the metal and strip any existing bluing). 
To deep clean rust from the pores of metal, first, clean the areas following above instructions. Then, apply another coat of Blue Wonder Gun Cleaner to the areas and while the gel is on the metal, use a propane torch and heat the areas to about 130 degrees Farenheit. (Remove or protect wood, plastic or composite components!) Heating the metal while the gel is on it, draws rust particles and residue out of the pores. While still hot, work the areas further with steel wool or brush and wipe clean with a dry cloth. Apply quality gun oil, Blue Wonder Disotec XFR, to prevent further rusting.
|
  |
|
| Technical
Support | Home Page | Support Request | Blue
Wonder Gun Cleaner Instructions | Blue
Wonder Gun Blue Instructions | Blue Wonder Gun Blue Tips & Techniques | Printable
Docs | Black
Powder Cleaning Instructions copyright © 2001-2011 Novum Solutions, Inc. All rights reserved. Blue Wonder and Micro-Penetration Technology are Trademarks of Novum Solutions, Inc.  |
||
|
||
